UCoat with UFlek AF

system_uflekaf_body_01system_uflekaf_body_02system_uflekaf_body_03system_uflekaf_body_04
The UCoat with UFlek-AF system is three coat system featuring our UCoat water based epoxy, UGloss-AF solvent based polyurethane top coat and our UFlek flakes. This system will provide a decorative, high gloss finish hiding minor imperfection in the substrate, while maintaining a chemical and abrasion resistant surface. Since the UGloss-AF top coat is a solvent based product it should be  applied in well ventilated (UGlaze or UGloss can be used as a substitute for less ventilated areas).

system_uflekaf_body_07system_uflekaf_body_08system_uflekaf_body_10system_uflekaf_body_11

steps_titlesteps_line

Step 1:  Prepare a bare cement surfaces for a UCoat It floor coating system with UPrep-CLC. Dilute 7:1 with water and apply to a wet surface. Agitate with a stiff-bristled brush and rinse clean.


steps_line

steps_line

Step 2:  UCoat epoxy is applied in two coats: the bond coat and the finish coat. The bond coat is applied directly to a dampened, prepared surface, allowing UCoat to flow and penetrate the porous concrete or wood floor and permanently bond to the substrate.


steps_line

steps_line

Step 3:  The UCoat finish coat is applied after the bond coat is dry to the touch (4-6 hrs @ 68°F/20°C), but within 48 hours.


steps_line

steps_line

Step 4:  UFlek vinyl flakes are broadcast on top of the tacky UCoat finish coat while it is still wet.


steps_line

steps_line

Step 5:  The UGloss-AF clear top coat is applied after the UCoat finish coat is dry to the touch (4-6 hrs @ 68°F/20°C), and within 48 hours.


steps_line

system_ucoat_body_v3_22system_ucladlv_body_10_02system_uflek_body_18

system_ucoat_body_24golf_ideal_maintenance_v5_body_12golf_ideal_maintenance_v5_body_11golf_ideal_maintenance_v5_body_10